Wine Cellar Build Planning Checklist
====================================
A stage-by-stage checklist for planning a private wine cellar, from choosing the room and specifying the envelope to commissioning the cooling unit and loading the first case.

[ ] Count the collection today and estimate where it will be in five and ten years, then run the Wine Cellar Bottle Capacity Planner at /tools/cellar-bottle-capacity/ against the room you have in mind.
[ ] Confirm that a built cellar is the right approach for your collection rather than a large wine cabinet or offsite storage; the comparison at /compare/ sets the five options side by side.
[ ] Pick the candidate room and log its temperature and humidity for at least a few weeks, including the warmest part of the day, before committing.
[ ] Note any exterior walls that take direct sun and any furnace, water heater, dryer, or duct run nearby that will add heat to the space.
[ ] Verify where the cooling unit will send its heat: an adjacent room large enough to absorb it, a ducted path to another space, or a location for an outdoor condenser.
[ ] Confirm a dedicated electrical circuit can reach the unit location and check the voltage and amperage the shortlisted units require.
[ ] Decide the target temperature and humidity and write both figures into the specification so every trade is working to the same numbers.
[ ] Specify the insulation R-value for the walls and ceiling and decide whether the floor needs insulating or can sit on cool earth.
[ ] Specify a continuous vapor barrier on the warm side of the insulation and detail how it laps at corners, around penetrations, and at the door frame.
[ ] Choose an exterior-grade insulated door with full weather stripping and a threshold sweep; if the door or wall is glass, insist on insulated double-pane at minimum.
[ ] Run the Wine Cellar Cooling Load Calculator at /tools/cellar-cooling-load/ with the real R-value, the total glass area, and the worst-case summer temperature difference.
[ ] Choose the cooling type, whether through-wall, ducted, or split, and confirm the rated capacity clears the design load with comfortable margin at your temperature difference.
[ ] Plan the condensate drain or evaporation method and make sure the unit can be reached for cleaning and service without unloading racks.
[ ] Choose the racking material and layout, confirm the aisle stays walkable once racks are in, and reserve a section for magnums and other large formats.
[ ] Lay out lighting on a switch or timer using cool-running fixtures placed away from the bottles, and keep any window covered or eliminated.
[ ] Obtain written quotes that itemize framing, insulation, electrical, cooling, racking, and finishes separately so bids can be compared line by line.
[ ] Check which permits and inspections your jurisdiction requires for electrical, mechanical, and structural work before demolition starts.
[ ] Choose interior finishes that tolerate sustained humidity and do not off-gas odors: sealed wood, stone, tile, and low-VOC coatings rather than fresh paint or carpet.
[ ] Install a temperature and humidity logger with remote alerts before the first case arrives, and place the sensor away from the cooling unit outlet.
[ ] Commission the cooling unit and run the empty cellar for at least a week to confirm it holds temperature and humidity through a warm day and cycles rather than running continuously.
[ ] Load the collection gradually, allowing warm bottles to settle, and record where each case is racked.
[ ] Estimate the annual running cost with the Wine Cellar Cost of Ownership Calculator at /tools/cellar-ownership-cost/ and set aside a replacement reserve for the cooling unit.
[ ] Put an annual service visit and a filter cleaning reminder in the calendar, and review the sensor log after the first full summer.